1999 ford ranger engine computer for sale

Introduction

If you own a 1999 Ford Ranger, you may be in need of a new engine computer. The engine computer, also known as the powertrain control module (PCM), is responsible for controlling various functions of the engine. When the engine computer fails, it can cause a variety of problems with the engine, such as poor performance, rough idle, and even engine stalling. In this article, we will discuss where to find a 1999 Ford Ranger engine computer for sale.

What is an Engine Computer?

The engine computer, or PCM, is a small electronic device that controls various functions of the engine. It receives input from various sensors located throughout the engine and uses this information to adjust fuel delivery, ignition timing, and other engine parameters. The engine computer also controls the transmission, emissions system, and other components of the vehicle.

Source: bing.com

Why Do You Need a New Engine Computer?

If your engine computer fails, it can cause a variety of problems with the engine, such as poor performance, rough idle, and even engine stalling. In some cases, the engine may not start at all. In addition, a faulty engine computer can cause the check engine light to come on, indicating a problem with the engine.

Where to Find a 1999 Ford Ranger Engine Computer for Sale?

If you need a new engine computer for your 1999 Ford Ranger, there are several options available to you. One option is to purchase a new engine computer from a Ford dealer. However, this can be expensive, and may not be the best option if you are on a tight budget.

Another option is to purchase a used engine computer from a salvage yard. Salvage yards often have a wide selection of used parts, including engine computers, at a fraction of the cost of a new part. However, when purchasing a used engine computer, it is important to ensure that it is in good working condition and compatible with your vehicle.

You can also purchase a remanufactured engine computer from an auto parts retailer. Remanufactured engine computers are rebuilt to factory specifications and come with a warranty. This can be a good option if you want a reliable part at a lower cost than a new part.

Source: bing.com

How to Replace Your Engine Computer

If you have decided to replace your engine computer, it is important to follow the proper procedure to ensure that it is installed correctly. Here are the basic steps for replacing your engine computer:

Disconnect the negative battery cable.
Locate the engine computer, which is typically located in the engine compartment or under the dashboard.
Disconnect the wiring harness and remove the mounting bolts to remove the old engine computer.
Install the new engine computer and reconnect the wiring harness.
Reconnect the negative battery cable.

It is important to follow the manufacturer’s instructions for your specific vehicle to ensure that the engine computer is installed correctly and functions properly.

Conclusion

If you are in need of a new engine computer for your 1999 Ford Ranger, there are several options available to you. Whether you choose to purchase a new part from a Ford dealer, a used part from a salvage yard, or a remanufactured part from an auto parts retailer, it is important to ensure that the part is in good working condition and compatible with your vehicle. By following the proper procedure for installation, you can ensure that your new engine computer functions properly and helps keep your vehicle running smoothly.

Ford f150 Trucks Ford f150 Trucks