Ford f150 Trucks Ford f150 Trucks
Neutral Safety Switch Ford F150 will wear and tear overtime. Owning a Ford F150 is a great experience, but from time to time, you may need to replace certain parts of your vehicle. One of the most important parts is the neutral safety switch. This switch is the one responsible for making your vehicle start, and without it, you wouldn’t be able to get anywhere.
What is a Neutral Safety Switch Ford F150?
The neutral safety switch is a safety device designed to prevent the vehicle from starting unless the transmission is in neutral or park. This switch is usually located in the left side of the transmission, and it consists of a switch, a solenoid, and a relay. The switch is connected to the starter, while the solenoid is connected to the ignition switch, and the relay is connected to the starter solenoid.
How Does the Neutral Safety Switch Ford F150 Work?
When you turn the key to the “on” position, the neutral safety switch sends an electrical signal to the starter solenoid, which then engages the starter. If the transmission is in gear, the switch will not send the signal, and the vehicle will not start. This is a safety feature designed to prevent the vehicle from starting while in gear, which could cause it to lurch forward and cause an accident.
When Should You Replace it?
If your Ford F150 is having trouble starting, the neutral safety switch may be the culprit. It is important to have it checked out and replaced as soon as possible. If the switch is left unchecked, the vehicle may start randomly, which can be dangerous. It is also important to note that the switch should be replaced if it has been damaged due to a collision or if it is worn out from regular use.
How to Replace it
Replacing the neutral safety switch is relatively simple. First, you will need to locate the switch, which is usually located in the left side of the transmission. Once you have located the switch, you will need to remove it by disconnecting the wiring harness and unbolting it from the transmission. Once it is removed, you will need to install the new switch, reconnect the wiring harness, and bolt the switch into place.